HTML by Rhodium
A wide range of methoxy-substituted benzenes and naphthalenes were regiospecifically iodinated at para position with N-iodosuccinimide in acetonitrile under mild conditions in excellent yields. Methylanisoles afforded only nuclear iodination products.
Iodination of aromatic compounds has been the subject of numerous studies1 due to the interest of iododerivatives as substrates for reactions involving C-C bond formation mainly mediated by transition metals2. These derivatives have been used in the synthesis of many interesting natural products3 and bioactive compounds4. Concerning iodination procedures, the moderate reactivity of iodine with aromatic substrates determined the use of different activating agents5 to effectively succeed in the goal. Iodonium donating reagents6 and other more sophisticated procedures7 have also been employed. The wide range of methods described so far revealed the lack of an efficient and general enough procedure.
We recently reported the use of N-bromosuccinimide (NBS) in acetonitrile as a mild and excellent nuclear brominating reagent for methoxybenzenes and naphthalenes8. Seeking for further extension of these results we thought of N-iodosuccinimide (NIS) as iodination agent. We report in this letter the ability of NIS to achieve nuclear iodination of activated aromatic compounds under very mild conditions and in good to excellent yields. Whereas NCS and NBS have been extensively used for many years9 as halogenating agents for aromatic substrates under different conditions, aromatic iodinations using N-iodoamides have been used in a lesser extent10.
Methoxy aromatic derivatives used in this study were commercially available. These compounds were submitted to reaction with NIS in CH3CN at different temperatures11. The results are collected in the Table. As can be seen, the products obtained in all cases resulted from the regiospecific iodination of the aromatic ring. The observed regiochemistry was the result of reaction through the presumably more electron rich and less sterically encumbered aromatic ring position. Thus, para positions of methoxybenzenes (entries 1, 5 and 6) and 4- and 1-position of methoxynaphthalenes (entries 9 and 10) were exclusively iodinated, whereas the ortho-iodination only ocurred when the para position was occupied (entries 4 and 7). As was found with NBS, chain iodination products were not detected in the reactions of NIS with methylanisoles under refluxing acetonitrile (entries 2-4).
The reactivity of the substrates seems to be associated to the electronic density of the aromatic rings. Thus, iodination of 1,3- and 1,4-dimethoxybenzene (entries 6 and 7) and 1,2,4-trimethoxybenzene (entry 8) took place at RT whereas the reactions of methoxybenzenes and naphthalenes (entries 1-4 and 9-10) and 1,2-dimethoxybenzene (entry 5) required refluxing acetonitrile to be completed. It is noteworthy that the activating effect of the substituents is only additive when they are not arranged on adjacent carbons. Thus, the influence of a second electron-donating substituent situated on a vicinal carbon on the reactivity is scarce (compare entries 1 with 2 and 6 with 8) or even negative (compare entries 1 with 5) when iodination can take place on a free para position. In the case of 1,2-dimethoxybenzene (entry 5), this could be a consequence of the lower activation of the reactive position 4 due to the OMe group situated at C-2 (meta).
Entry |
Substrate |
NIS (Eqv.) |
Temp |
Time |
Product |
Yield (Crude) |
1 | Anisole | 1.5 | 82°C | 6 h |
4-Iodoanisole | 95% |
2 |
2-Methylanisole | 1.5 | 82°C | 8 h |
4-Iodo-2-Methylanisole | 96% |
3 |
3-Methylanisole | 1.5 | 82°C | 2 h |
4-Iodo-3-Methylanisole | 90% |
4 |
4-Methylanisole | 1.5 | 82°C | 8 h |
2-Iodo-4-Methylanisole | 90% |
5 |
1,2-Dimethoxybenzene | 1.5 | 82°C | 18 h |
4-Iodo-1,2-Dimethoxybenzene | 85% |
6 |
1,3-Dimethoxybenzene | 1.1 | 20°C | 5 h |
1-Iodo-2,4-Dimethoxybenzene | 90% |
7 |
1,4-Dimethoxybenzene | 1.1 | 20°C | 16 h |
2-Iodo-1,4-Dimethoxybenzene | 95% |
8 | 1,2,4-Trimethoxybenzene | 1.1 | 20°C | 4 h |
1-Iodo-2,4,5-Trimethoxybenzene | 95% |
9 |
1-Methoxy-naphtalene | 1.5 | 82°C | 6 h |
4-Iodo-1-Methoxy-naphtalene | 97% |
10 |
2-Methoxy-naphtalene | 1.5 | 82°C | 24 h |
1-Iodo-2-Methoxy-naphtalene | 96% |
We have also checked the influence of solvent polarity on the reactivity. When these reactions were performed using CCl4, the reactivity observed was lower than in CH3CN. Thus, the reaction of the most reactive substrates in the Table (1,3-dimethoxy- and 1,2,4-trimethoxybenzenes) required 4 days in refluxing CCl4to be completed, whereas the less reactive ones (2-methyl- and 2-methoxyanisole) were recovered unaltered after 5 days in the same conditions. These results evidenced the important role of the solvent polarity to achieve an efficient iodination with NIS. A similar effect was observed in bromination with NBS, where the reactions in CH3CN were faster than in CCl4. The regioselectivity observed (para iodination prefered when possible) revealed the influence of steric grounds on the reaction. The different reactivity of the studied aromatic substrates (the more electron rich reacted faster) and the effect of solvent polarity on the efficiency of the reaction suggested an aromatic electrophilic halogenation-type mechanism, with the succinimide anion acting as leaving group at the first step (formally a SN2 reaction at halogen) and as a base in the subsequent deprotonation of the Wheland intermediate12. The lower reactivity of NIS with respect to NBS could be explained by assuming that the nucleophilic attack on iodine is less favoured than on bromine due to the higher size and lower positive charge density of the former13.
In order to take advantage of this highly regioselective iodination in a controlled mixed dihalogenation, we performed the reaction of 4-iodo-3-methylanisole with NBS/CH3CN14. Unfortunately, the method was not preparatively useful and after 3 days at RT we obtained a complex mixture where 6-bromo-4-iodo-3-methylanisole and 4-bromo-3-methylanisole were detected as major components in a similar proportion, indicating that the reactivity of C-4 adjacent to the methyl substituent was as large as that of the less hindered C-6 contiguous to the methoxy group. The well contrasted higher reactivity of the system NBS/H2SO49e did not allow us to achieve the regioselective bromination. The reaction of the above substrate with NBS/p-TsOH15 at RT yielded a ca. 60:40 mixture of the 2-bromo and 6-bromo derivatives.
In conclusion, the regiospecific nuclear iodination of aromatic methoxy derivatives can be efficiently achieved with NIS in CH3CN. These results broaden the range of application of N-halosuccinimides and provide a mild and controlled entry into substituted aromatic iododerivatives widely used in organic synthesis. We are now extending the utilization of this method in the iodination of highly functionalizated aromatic derivatives in order to evaluate its compatibility with a range of functional groups.
Representative procedure11
To a solution of 1 mmol of the aromatic compound in 4 ml of CH3CN, 1.5 mmol NIS was added and the reaction was stirred at the desired reaction temperature. After the time required in each case, the solvent was evaporated and ether added. The etheral phase was washed with aqueous NaHSO3 solution followed by water. The ether layer was dried over MgSO4 and evaporated to give the crude compound. [Purification method (Distillation/Recrystallization/Chromatography) depends on the product]